648-247 CCPS2 Implementing Cisco Connected Physical Security 2 Exam

Posted by

648-247 CCPS2
Implementing Cisco Connected Physical Security 2 Exam

Exam Number 648-247
Duration 60 minutes (50-60 questions)
Available Languages English, Japanese
Register Pearson VUE
Exam Policies Read current policies and requirements
Exam Tutorial Review type of exam questions

This exam tests the Sales and Field Engineer’s knowledge of the Cisco Physical Access Control solution. Candidates will be tested on knowledge of the basics of physical access control and the Cisco Physical Access Manager software solution. In addition, the candidate will also be asked questions regarding the PAC hardware components consisting of the MSP server platform, Access Control gateway and I/O modules, and 3rd party devices. Candidates can prepare for this exam by taking the CPAM course offered by Cisco Advance Services Education.

Exam Topics
The following topics are general guidelines for the content likely to be included on the exam. However, other related topics may also appear on any specific delivery of the exam. In order to better reflect the contents of the exam and for clarity purposes, the guidelines below may change at any time without notice.

Access control basics, legacy vs Cisco architectures
Hardware/software
Integration with 3rd party data systems
CPAM configuration workflow
High availability
Users, badges, I/O, edge policies, and maps
Schedules, backup, and troubleshooting

QUESTION 1
When a 24 VDC fail safe lock is being used to secure a door, how should power be supplied to the lock from the control source?

A. connected +24 VDC directly to the lock
B. connected +24 VDC through common and normally close
C. connected +24 VDC through common and normally open
D. connected +5 VDC binary control signaling


QUESTION 2
What are the three common methods that are used for authentication with an access control system?

A. badge card, key fob, and keypad PIN
B. badge card, keypad PIN, and password
C. something you know, something you have, and something you are
D. something you know, something you have, and something you did


QUESTION 3
Refer to the exhibit.

One or more expansion modules is connected to the Cisco Access Gateway via a CAN bus. How
should the CAN bus wires be connected after the last module in the chain?

A. The CAN bus wires should be looped back to the Cisco Access Gateway.
B. The CAN bus wires should be twisted together and tucked away.
C. The CAN bus wires should be plugged into a Layer 2 Ethernet switch.
D. The CAN bus wires should be terminated with a high-impedance resistor.

Answer: D

Explanation:


QUESTION 4
What are the four main components of a typical logical door?

A. door, door knob, door jam, and hinges
B. lock, reader, tailgate sensor, and motion detector
C. lock, request to exit, door position switch, and swing arm
D. lock, reader, request to exit, and door position switch

Explanation:


QUESTION 5
Cisco Physical Access Manager (Cisco PAM) is an appliance-based solution. The Cisco PAM
1.3.2 appliance is available on which of the following server platforms?

A. CIVS-MSP-1RU-K9
B. CPS-MSP-1RU-K9
C. CPS-MSP-2RU-K9
D. CIAC-PAME-1125-K9

 

Certkingdom 20% Discount Promotion Coupon Code: 45K2D47FW4

Click here to view complete Q&A of 648-247 exam

MCTS Training, MCITP Trainnig

Best Cisco 648-247 Certification, Cisco 648-247 Training at certkingdom.com

Click to rate this post!
[Total: 0 Average: 0]

Leave a Reply

Your email address will not be published. Required fields are marked *